Step-by-step tool zeroing on the Mitsubishi M70/M700 with a reference tool: CNT SET and RELATIVE POSN screen, EASYSETTING for Z zero, MDI tool change and entering length differences on the T-OFS page.
Read more
Program Restart Type 2 on the Mitsubishi M70/M700: MONITOR-RESEARCH-TYPE 2, Top Search and File Set, entering a line/block number, modal G-code check, G43 and G41/G42 risks, Type 3 and a safe start.
Read more
Restarting an interrupted program with Program Restart Type 1 on the Mitsubishi M70/M700: MONITOR-RESEARCH-TYPE 1, restart search, MSTB History (M S T B), tool/speed/coolant selection and a safe restart with low override.
Read more
Stopping and canceling a program on the Mitsubishi M70/M700: FEED HOLD, SINGLE BLOCK, M00/M01, cancel with RESET, reset to start with TOP SEARCH, resume vs restart and EMERGENCY STOP.
Read more
Deleting, copying and backing up programs on the Mitsubishi M70/M700: single/bulk delete, line vs program delete, MEMORY PROTECT, copy under a different O number, backup to USB/CF card and restore with subprograms.
Read more
Transferring a program from a computer and DNC on the Mitsubishi M70/M700: RS-232/Ethernet/Host Link, communication settings, sending to NC memory, direct running in DNC/TAPE mode and connection loss.
Read more
Calling a program from a CF card and USB memory on the Mitsubishi M70/M700: device selection, file preparation, copy to NC memory, source/target direction, same O number, direct external running and File I/O error.
Read more
Running a program in NC memory safely on the Mitsubishi M70/M700: AUTO/MEMORY mode, CYCLE START, Feed/Rapid Override, SINGLE BLOCK, stopping with FEED HOLD, the effect of RESET and program-end checks.
Read more
Finding and calling a program in NC memory on the Mitsubishi M70/M700: program list, device (MEMORY) selection, searching by O number, TOP SEARCH reset to start and EDIT/MONITOR active-program check.
Read more
Creating a new program on the Mitsubishi M70/M700: switching to EDIT mode, creating an O program number, writing lines, using EOB, INPUT/INSERT/ALTER, inserting/deleting lines, M30 program end and save check.
Read more