CNC Controls

Deleting, copying and backing up programs on the Mitsubishi M70/M700: single/bulk delete, line vs program delete, MEMORY PROTECT, copy under a different O number, backup to USB/CF card and restore with subprograms.

Transferring a program from a computer and DNC on the Mitsubishi M70/M700: RS-232/Ethernet/Host Link, communication settings, sending to NC memory, direct running in DNC/TAPE mode and connection loss.

Calling a program from a CF card and USB memory on the Mitsubishi M70/M700: device selection, file preparation, copy to NC memory, source/target direction, same O number, direct external running and File I/O error.

Running a program in NC memory safely on the Mitsubishi M70/M700: AUTO/MEMORY mode, CYCLE START, Feed/Rapid Override, SINGLE BLOCK, stopping with FEED HOLD, the effect of RESET and program-end checks.

Finding and calling a program in NC memory on the Mitsubishi M70/M700: program list, device (MEMORY) selection, searching by O number, TOP SEARCH reset to start and EDIT/MONITOR active-program check.

Creating a new program on the Mitsubishi M70/M700: switching to EDIT mode, creating an O program number, writing lines, using EOB, INPUT/INSERT/ALTER, inserting/deleting lines, M30 program end and save check.

CNC program management on the Mitsubishi M70/M700 control: program vs block vs command, O and N numbers, NC memory/CF card/USB/DNC, operating modes, Feed Hold, Reset and Cycle Start.